Publicité
Adjusting support foot
Turn the support foot clockwise or
counterclockwise depending on the amount of
support needed for making slide cuts.
(Fig. 27).
SAW OPERATIONS
Power switch
The power switch has a secondary LOCK-OFF
tab that must be rotated to the left to be able
to depress the power switch. Grasp the main
handle with your fingers and flip the tab to the
left. Then pull the power switch to activate the
saw. Release the power switch to stop the
saw. (Fig. 28)
LED shadow light
WARNING
distance) . Staring into the light beam may
result in serious injury or vision loss.
NOTE: The miter saw must be connected to a
power source for the Shadow Light System to
function.
The LED Shadow Light System is equipped
with an ON/OFF switch (Fig. 29). Power to the
Shadow Light System is independent of the
miter saw trigger switch. The Shadow Light does
not need to be turned on to operate the saw.
To cut through an existing pencil line on a
workpiece, turn on the Shadow Light System,
then pull down on the operating handle to bring the saw blade close to the workpiece. The
shadow of the blade will appear on the workpiece. This shadow line represents the material
that the blade will remove when performing a cut. To correctly locate your cut to the pencil line,
align the pencil line with the edge of the blade's shadow. Keep in mind that you may have to
adjust the miter or bevel angles to match the pencil line exactly.
30
Do not stare into the light
beam (not even from a
Fig . 27
Support bolt
Fig . 28
2
1
Main Switch
Fig . 29
Lock-Off Tab
Shadow
Light On/
Off Switch
Publicité
