Publicité
Removal and installation of the blade
WARNING
equal or higher than the speed marked on the tool.
WARNING
WARNING
WARNING
Larger blades will come in contact with the blade guards and/or chip deflector, while smaller
blades will defeat the function of the chip deflector which could result in blade guard damage
which could put user at risk.
Clean the blade of any excess oil before installation.
NOTICE
To remove the blade:
1. Position the head assembly in the up position and at 0° bevel. Tighten the slide-rail lock
knob so that the head assembly is secured in place. (See "ADJUSTMENTS" and Fig. 3)
2. Rotate the lower guard by hand, then loosen but do not remove the blade-bolt-cover screw
with the Phillips end of the Double-Ended Allen Key (Fig. 3).
3. Continue to rotate the lower guard in order for the blade cover to move along with the
lower guard, so that the blade bolt is exposed (Fig. 3).
4. Press and hold the spindle-lock button. Use the hex-end of the Double-Ended Allen Key to
remove the blade bolt by turning the Allen key clockwise (Fig. 3).
Fig . 3
Blade bolt
cover
The blade bolt has left-hand
NOTICE
threads.
5. Remove the blade bolt, the outer blade
washer, and the blade. Do not remove the
inner blade washer (Fig. 4).
To install the blade:
1. To install the blade, fit the blade between
the chip deflectors and onto the inner
washer shoulder (Fig. 3 and Fig. 4).
Always install the blade with the
NOTICE
blade teeth and the arrow printed on
the side of the blade pointing down at the front of
the saw. The direction of blade rotation is also
embossed with an arrow on the upper blade guard.
Only use wood-cutting blades that have a saw-blade diameter in
accordance with the markings on the saw and are marked with a speed
Use only 7-1/4" (185 mm) blades with 5/8 in . arbor hole and blade kerfs
less than or equal to 3/32 in. (2.2 mm).
To reduce risk of injury, use saw blade rated 5200/min (RPM) or greater .
Use of blades larger or smaller than indicated in the miter saw markings
could result in blade-guard and chip-deflector damage.
b
Blade bolt
cover screw
Spindle lock
button
a
d
Blade bolt
Fig . 4
Blade bolt
Outer blade
washer
Blade
c
Inner washer
shoulder
Spindle
Inner blade
washer
19
Publicité
