Publicité
MOUNTING AND
TRANSPORTING
WARNING
transporting miter saw to avoid possible injury.
Mounting the saw to the
workbench (Fig . 8a, 8b)
WARNING
and follow the instructions for the miter saw
stand. Never operate your miter saw on the
floor or in a crouched position. Failure to heed
this warning can result in serious personal
injury.
The miter saw should be mounted to a firm supporting surface such as a workbench, mounting
board, or miter saw stand. The saw base has four mounting holes. If using bolts or screws (not
supplied), they should be of sufficient length to accommodate the saw base, lock washers,
hex nuts, and the thickness of the workbench
or other mounting surface. Tighten all bolts or
screws securely.
The hole pattern for mounting to a workbench
is shown in Fig. 8a. Carefully check the
workbench after mounting to make sure that
no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the
workbench to the floor before operating.
Temporary mounting, using clamps
If necessary, clamp the miter saw to a
•
workbench or table top.
Place two (2) or more "C" clamps on the
•
clamping areas and secure (Fig. 8b).
NOTE: Always make sure you leave enough
room in work area to accommodate long workpieces.
Transporting
WARNING
Unplug the electric cord and wind it up .
•
Never lift the saw by gripping any of the mechanism parts . The saw may move and
•
cause severe injuries to your fingers or hands.
To avoid back injury, hold the tool close to your body when lifting . Bend your knees so
•
you can lift with your legs, not with your back.
Never lift the tool by holding the main handle . This may cause serious damage to the tool.
•
Never lift the miter saw by the power cord . Attempting to lift or carry the tool by the power
•
cord will damage the insulation and the wire connections, and possibly result in electric
shock or fire.
Place the saw on a firm, level surface where there is plenty of room for handling and
•
22
Disconnect plug from power
source before mounting or
If a miter saw stand is used,
read the operator's manual
To avoid injury, follow all instructions identified below by the Bullet (•)
symbol .
Fig . 8a
Workbench
Base
Mounting holes
Fig . 8b
Publicité
