Publicité
Cutting Oil System
1. Ensure that the oil flows freely. Check that there
is enough oil in the tank and that all oil lines are
unobstructed.
2. If oil becomes discoloured or contaminated, drain
the tank and refill with fresh cutting oil.
3. Clean the oil filter after every 8 to 12 operating
hours.
4. During thread cutting operations, small chips from
the threads will accumulate in the tank therefore
efficient cleaning is essential once a month to
ensure proper operation of the threading machine.
Hammer Chuck Structure and Maintenance
The hammer chuck jaw incorporates 3 parts and when
the teeth on the chuck jaw become worn and fail to
hold the pipe correctly, replace the entire set of chuck
jaw inserts.
Remove the hex socket set screw.
24
MACHINE PREPARATION
ENGLISH
Publicité
