Safety Features; Cleaning And Maintenance; Ce-Statement - EUROM RK500 Manuel D'utilisation

Safety features

In case of internal overheating, the overheating safeguard will switch the heater off. This may occur if the heater cannot
give off enough heat or if it or cannot draw in enough fresh air. As mentioned above, this is generally caused by
(partially) covering the heater, obstructing the air intake and/or outlet grills or installing the heater too close to a wall or
something similar. When the overheating safeguard has switched the heater off, you need to set the output-button to
'OFF' (off) and unplug the heater. Give the heater time to cool down, remove the source of the overheating and use as
normal. If the problem persists or if you have not been able to trace the source of the overheating, turn the heater off
immediately and unplug. Contact a service point to have the heater repaired.

Cleaning and Maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of overheating so these should be
removed regularly. Switch off the heater, remove the plug from the socket and allow the heater to cool down before
cleaning or carrying out maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive soaps, sprays,
cleaners or abrasives, waxes, polishes or chemical solutions!

Carefully use a vacuum cleaner to remove dust and dirt from the grills.

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if possible. Store upright in a cool, dry
and dust-free place.

Do not dispose of heater with household waste when if becomes worn or damaged beyond repair. Take it to your
local authority's collection point for electrical appliances where any reusable materials will be collected and
redistributed.

CE-statement

Euromac bv, Genemuiden-NL hereby declares that the EUROM oil filled radiator heater, type RK500, complies with
the LVD guideline 2006/95/EC and the EMC guideline 2004/108/EC and meets the following standards:
EN 60335-1:2002+A1+A11+A12+A2+A13
EN 60335-2-30:2003+A1+A2
EN 62233:2008
Genemuiden, 18-05-2011
EN 55014-1 :2006
EN 55014-2 :1997+A1
EN 61000-3-2 :2006
EN 61000-3-3 :1995+A1+A2
W.J. Bakker, alg.dir,
11