Publicité
4
Mounting
8021265/1OPE/2024-10-09 | SICK
Subject to change without notice
NOTE
When configuring the switch-on current, observe
Figure 1: Configuring the switch-on current
Ensure that the supply voltage to the motor feedback system's DSL female contact (10)
is from +7 V to +12 V.
This chapter describes the mounting of the safe motor feedback system.
NOTE
Depending on the motor design, it may be necessary to perform the electrical installa‐
tion before the mechanical mounting.
NOTE
If the safe motor feedback system has to be removed, the mounting steps are to be
carried out in reverse order.
NOTE
No impacts or shocks are permitted during the mounting of the motor feedback system.
OPERATING INSTRUCTIONS
figure
1.
O P E R A T I N G I N S T R U C T I O N S | EES37-2...
EEM37-2...
en
25
Publicité
