Publicité
4. Press the
weight. The display will show a series of digits (
o
Press the
Press the
o
o
Press the
calibration weight that is at least 2/3 of the full capacity for better accuracy.)
5. Press the
6. When the stable indicator is displayed, press the
7. Place the known test weight on the platform. Once the stable indicator appears, press the
again. The display will show ------ followed by the AD value, indicating that calibration is complete.
8. Turn off the product and remove the test weight from the platform.
9. Press the
repeat the above steps.
Disposing of Used Devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device recycling
and collection point. Check the symbol on the product, instruction manual and packaging. The plastics used to
construct the device can be recycled in accordance with their markings. By choosing to recycle you are making a
significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
key again, and the display will show
key to move the flashing digit to the right.
key to increase the value of the flashing digit.
key to confirm. The display will show
key. The display will show
key to turn the product back on and check if the weighing is accurate. If it is not,
EN
. Press the Unit key to set the calibration
) with one flashing.
again. It is recommended to use a
and then the AD value.
key. The calibration weight will flash.
key
Publicité
