Publicité
• Check the wear status of the brake pads
at regular intervals and replace them
when the braking surfaces reach the limit
marked by the wording "WEAR LIMIT" or
if braking power is in any way insufficient
(Fig. 12).
• Periodically check that the brake pads
are about 1 mm from the surface of the rim
(Fig. 13). If this is not the case, adjust the
distance using the cable tension adjustment
screw (C - Fig. 14). If this proves insufficient,
loosen the cable securing screw (B - Fig. 14),
adjust the distance of the pads to the rim,
reset the position of the cable and secure it
again by tightening the cable retainer screw
(B - Fig. 14).
~1 mm
13
22
5 - BRAKE MAINTENANCE
~1 mm
The wear limit is the bottom
of the grooves.
12
B
14
WARNING!
C
ENGLISH
Publicité
