• Fit the brake on the frame or the fork
and tighten the socket-head nut (A - Fig. 1)
using a 5 mm Allen wrench.
• Secure the cable by tightening the cable
retainer screw (B - Fig. 1) with a 5 mm Allen
wrench or Torx T25 wrench to a torque of
5 N.m - 44 in.lbs.
WARNING!
Please be sure that you tighten the
cable sufficiently, without crushing the
cable, so that it does not slip when
brakes are applied. A loose or dama-
ged cable can cause the brake system
to malfunction resulting in an accident,
personal injury or death.
• Initially center the brake in relation to
the wheel using the lock-nut (D - Fig. 2)
and a 12 mm open end wrench in order to
position the brake pads about 1 mm from
the surface of the rim (Fig. 3).
If necessary, perform fine adjustment using
the cable tension adjustment screw (C -
Fig. 1).
ENGLISH
2 - ASSEMBLY
5 Nm (44 in.lbs)
1
2
3
A
B
D
~1 mm
~1 mm
C
17