Publicité
ASSEMBLY INSTRUCTIONS
Congratulations on your purchase of the KS7190 Single-X Keyboard Stand.
Please read the below instructions carefully.
We hope you enjoy your new purchase!
PREPARATION
Remove the following parts from the box and identify all the parts:
(2) 13" support
(1) X-frame
arms
© 2008 TMP, Inc.
Designed and engineered in the USA
Printed and manufactured in China
www.onstagestands.com
KS7190 Single-X Keyboard Stand
(2) 23" floor
(1) Allen
supports
wrench
Continued on back
Continued from front
ASSEMBLING INSTRUCTIONS
1. Take the X-frame and set the disk clutch
in the middle position for ease of setup and
balance of stand. Place stand upright so
that the pull knob is above the bolt.
2. With the knob on the X-frame facing you,
remove the black hex bolt from the top of
the left leg. Take the left 13" support arm (as
indicated in Figure A) and insert the black
hex bolt through the dimpled hole and into
the top of the left leg of the X-frame. Use
allen wrench to tighten. Figure C
3. Remove the black hex bolt from the top
of the right leg. Take the right 13" support
arm (as indicated in Figure A) and insert
the black hex bolt through the dimpled
hole and into the top of the right leg of the
X-frame. Use allen wrench to tighten.
Figure C
4. Turn stand upside down so it is resting on
the support arms.
5. With the knob on the stand facing you,
remove the black hex bolt from the left leg.
Take the left 23" floor support (as indicated
in Figure B) and insert the black hex bolt
through the dimpled hole and into the left
leg of the X-frame. Use allen wrench to
tighten. Figure C
6. Remove the black hex bolt from the
right leg. Take the right 23" floor support
(as indicated in Figure B) and insert the
black hex bolt through the dimpled hole
and into the right leg of the X-frame.
Tighten. Figure C
7. Double check that all hex bolts are tight
before placing any equipment on the stand.
© 2008 TMP, Inc.
Designed and engineered in the USA
Printed and manufactured in China
www.onstagestands.com
Figure A
Figure B
back of stand
back of stand
install on
install on
install on
install on
left leg
right leg
left leg
right leg
front of stand
front of stand
Figure C
Step 3
Step 2
Pull spring
loaded knob to
change height
position.
Step 6
Step 5
WARNING! DO NOT ADJUST
THE HEIGHT WITH A
KEYBOARD ON THE STAND!
Publicité
