Publicité
IMPORTANT SAFETY
INSTRUCTIONS
• Only use the machine on firm, level
surfaces. DO NOT use the machine on
gradient or slope of more that 2%.
• CAUTION–This machine is for dry, indoor
use only and should not be used or stored
outdoors
or in wet conditions. Protect from rain.
• Take care when using this machine near
the top of stairs to avoid loss of balance.
• DO NOT cover the machine when in use.
• DO NOT run the machine dry as this could
damage the floor surface and/or the
machine itself.
• DO NOT leave the machine running
unattended.
• Keep hair, loose clothing, hands, feet,
and all other parts of the body away from
openings and moving parts. Do not put
hands under base as rotating parts can
cause injury.
• DO NOT put any object into openings. DO
NOT use with any opening blocked. Keep
free of dust, debris and anything that may
reduce airflow.
• DO NOT use volatile or combustible
solvents (e.g., diesel, petrol, PA,
trichloromethane) nor any corrosive, toxic,
or highly irritant substance to wash floors,
even if diluted. In the event of accidental
contact with any such substances (e.g.,
due to spills) follow the decontamination
procedures in force at the user site. If
in any doubt about the condition of the
machine, contact Tornado or the dealer/
agent who supplied the machine.
• DO NOT leave the machine unattended
when plugged in. Switch Off when not
SAVE THESE INSTRUCTIONS
in use and before changing brushes
or attempting any maintenance or
adjustment.
• DO NOT fill the machine with water hotter
than 104°F (40°C).
• When used on escalators, ensure the
machine is positioned at the bottom of
the escalator with the escalator moving
towards the operator.
• DO NOT pull or carry by cord, use cord as
a handle, close a door on cord, or pull cord
around sharp edges on corners.
• DO NOT run machine over cord. Keep cord
away from heated surfaces.
• DO NOT unplug by pulling on cord. To
unplug, grasp the plug, not the cord. Do
not handle plug or machine with wet hands.
Turn off all controls before unplugging.
• Connect only to a properly grounded
outlet. See grounding instructions.
• Use care to keep electrical supply cable
from contacting moving parts such as floor
brushes.
• Make sure voltage and frequency at the
wall receptacle correspond with that
indicated on nameplate before plugging in
machine.
• The machine must be kept clean and in
good condition. If any parts are damaged,
they shall only be replaced by an approved
part by the manufacturer, its service agent
or a similar qualified person in order to
avoid a hazard.
• Only replace the power cord with original
OEM equipment.
4
Publicité
