Publicité
ASSEMBLY
Adjustment Of The Squeegee
In order to have a perfect drying result through the squeegee, the rear rubber must
have the lower bending uniformly adjusted in all its length. For the adjustment, it
is necessary to put the unit in working condition and therefore the suction motor
has to be switched on and the brushes have to function together with the detergent
solution.
The Bending Is Not Uniform
Adjust the squeegee inclination rotating counterclockwise the wing nut (1) to
increase the bending in the central part, or clockwise to increase the bending on the
extremities.
Height adjustment
Once the squeegee inclination has been adjusted, it is necessary to fix this optimum
condition making the wheels lightly touch the floor. Release the wheels rotating
counterclockwise the register (2), rotate the register (3) to raise or to lower the
wheels until the desired bending is reached.
At the end block again the wheels through the register (2).
Splash Guard Assembly
The two splash guards have to be assembled onto the brushes base group. Insert
the metal strips inside the slots on the rubber. Place the round hole at the flat
extremity of the strip onto the screw placed in the front of the cover. Secure the
strips with the nut.
15
Publicité
