Publicité
3. Check on the display that the activation signal of the brushes motor is on.
4. Check that the battery connector is correctly plugged in.
5. Activate the levers drive control (3).
If the problem persists, please contact the authorized technical assistance.
The Traction Motor Does Not Work
1. Switch the machine off and on again.
2. Release the parking brake (1) until the signal on the display goes off.
3. Activate the levers drive control (2).
If the problem persists, please contact the authorized technical assistance.
The Detergent Solution On The Brushes Is Not Sufficient
1. Check that the solution valve lever (1) is open.
2. Check the level of the liquid in the solution tank.
3. Check that solution filter is clean (see under paragraph "CLEANING OF THE
SOLUTION FILTER").
FAULT DIAGNOSIS
39
Publicité
