Publicité
Batteries Recharging
1. Bring the machine on a leveled surface.
2. Plug in the connector (1) of the battery recharger to the batteries connector
(2) placed in the rear part of the machine.
3. Proceed with the recharging keeping the recovery tank lifted (see under
"ACCESS TO THE BATTERY COMPARTMENT").
4. Maintain the connection with the battery recharger until the indication of the
end of charge is observed on the charger.
Batteries Recharging With On-Board Charger (Optional)
Bring the machine on a leveled surface near to a single-phase 120V 60 HZ socket
(within 2 m), nominal current 10A.
Switch off the machine and proceed as follows.
1. Insert the plug into the mains socket.
2. Proceed to the recharging keeping the recovery tank lifted (see under
paragraph "ACCESS TO THE BATTERY COMPARTMENT" in "BEFORE USE").
3. Do not take off the plug from the mains socket until the end of charge. At the
end of the recharging, remove the plug from the mains socket.
Never disconnect the batteries connector during the
recharging phase.
ASSEMBLY
13
Publicité
