Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL WIRING
14.2. ELECTRICAL WIRING CONNECTION FOR
OUTDOOR UNITS
The electrical wiring connection for the outdoor unit is shown
•
in figure below:
3~5HVRNME
Table for Terminal Connection
Wiring
System
Power Supply
DC inverter
Operating
DC inverter
Remote Control DC inverter
O.U.: Outdoor Unit; I.U.: Indoor unit
Instructions for wiring and electrical Board
•
14.2.1. SETTING OF DIP SWITCHES FOR OUTDOOR
UNIT
¡
Quantity and Position of DIP Switches
The PCB in the Outdoor Unit is operating with 5 types of DIP
Switches, 1 Slide Switch and 3 Push Switch. The location is
as follows:
PMML138A_R1-eng-fre.indb 36
4~5HRNME
[Connection (Connection of
Terminals)]
[O.U.-O.U.(L1-L1, L2-L2, L3-L3, N-N)]
[I.U.-I.U.(L1-L1, N-N)]
[O.U.-I.U., I.U.-I.U.(1-1, 2-2)]
[I.U.-I.U.(A-A, B-B)]
¡
DSW1: For Test Run
Setting before shipment
¡
DSW2: Optional Function Setting
Setting before shipment
NOTE:
- In case of using DHWT and Heat in summer operation,
DSW2 PIN4 will be ON.
¡
DSW3: Capacity
3HVRNME
5HVRNME
Setting position
4HRNME
¡
Refrigerant Cycle No. Setting
DSW4
Setting position
(Setting for the ten digit).
RSW1
Setting position.
(Setting for the last digit).
¡
DSW5: Transmission Setting of End Terminal Resistance
Setting before shipment
¡
DSW6: Function setting (No setting is required)
Power source setting
DANGER:
- Do not connect of adjust any wiring or connections unless
the main power switch is OFF.
- Check that the earth wire is securely connected, tagged
and locked in accordance with national and local codes.
NOTE:
- Check and test to ensure that if there is more than one
source of power supply, that all are turned OFF.
PMML0138A-rev.1 - 11/2009
4HVRNME
5HRNME
400 V
230 V
36
19/11/2009 14:46:02
Publicité
