Parkside PKS 1500 C4 Consignes D'utilisation Et De Sécurité page 7

2 Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability for
damage to the product or caused by the product arising
from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed.
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your product and to use it for its intended
purpose.
The operating manual includes important instructions for
the safe, proper and economic operation of the product,
for avoiding danger, for minimising repair costs and
downtimes and for increasing the reliability and extend-
ing the service life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations applica-
ble to the operation of the product in your country.
Keep the operating manual package with the power tool
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and carefully
observed by all operating personnel before starting the
work.
The product may only be used by personnel who have
been trained to use it and who have been instructed with
respect to the associated hazards.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such products must also be observed.
We accept no liability for accidents or damage that oc-
cur due to a failure to observe this manual and the safe-
ty instructions.
3 Product description (Fig. 1-16)
1. On/off switch
2. Locking switch
3. Handle
4. Saw head
5. Moving saw blade guard
5a. Fixing screw
6. Saw blade
7. Locking screw for rotary table
8. Stop rail
8a. Moveable stop rail
8b. Locking screw
9. Fixed saw table
10. Table inlay
11. Scale
12. Pointer
13. Rotary table
14. Locking screw for workpiece support
15. Clamping device (workpiece clamp)
16. Locking screw
17. Dust bag
18. Workpiece support
19. Locking screw for clamping device
20. Locking screw for tilt protection
21. Stand bracket
22. Adjustment screw (45°)
22a. Adjustment screw locknut (45°)
23. Locking screw
24. Clamping handle
25. Locking pin
26. Adjustment screw (90°)
26a. Adjustment screw locknut (90°)
27. Scale
28. Pointer
29. Flange screw
30. Outer flange
31. Guide bar
32. Sawing shaft lock
33. Laser ON/OFF switch
34. Battery cover
35. Laser
36. Screw (laser)
37. Transport handle
A. 90° engineers square (not included in the scope of
delivery)
B. 45° engineers square (not included in the scope of
delivery)
C. Allen key, 6 mm
D. Allen key, 3 mm
E. Philips screw (table inlay)
4 Scope of delivery
Item Quantity Designation
15. 1 x Clamping device (workpiece clamp)
17. 1 x Dust bag
18. 2 x Workpiece supports
21. 1 x Stand bracket
GB / IE / NI / CY / MT | 3