Parkside PKS 1500 C4 Consignes D'utilisation Et De Sécurité page 20

18 Troubleshooting
Fault
Motor does not work
The engine runs slowly and
does not reach the operating
speed.
Engine producing excessive
noise.
The engine does not reach full
power.
Motor overheats easily.
Saw cut is rough or wavy.
Workpiece pulls away and/or
splinters.
16 | GB / IE / NI / CY / MT
Possible cause
Engine, cable or connector
defective, mains fuses blown.
Voltage too low, coils dam-
aged, capacitor burnt.
Coils damaged, motor de-
fective.
Circuits in the network are
overloaded (lamps, other
motors, etc.).
Overloading of the motor,
insufficient cooling of the
motor.
Saw blade dull, tooth shape
not appropriate for the ma-
terial thickness.
Excessive cutting pressure
and/or saw blade not suit-
able for use.
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check
mains fuses and replace as necessary
Have an electrician check the voltage. Arrange for in-
spection of the motor by a specialist. Arrange for re-
placement of the capacitor by a specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other products or motors on the same
circuit.
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor.
Resharpen saw blade and/or use suitable saw blade.
Insert suitable saw blade.