Parkside PKS 1500 C4 Consignes D'utilisation Et De Sécurité page 11

• Only use saw blades for which the maximum per-
missible speed is not lower than the maximum spin-
dle speed of the saw and which are suitable for the
material to be cut.
• Observe the direction of rotation of the saw blade.
• Only use saw blades if you have mastered their use.
• Observe the maximum speed. The maximum speed
specified on the saw blade may not be exceeded. If
specified, observe the speed range.
• Clean dirt, grease, oil and water off of the clamping
surfaces.
• Do not use any loose reducing rings or bushes for
the reducing of holes on saw blades.
• Make sure that fixed reducer rings for securing the
saw blade have the same diameter and have at least
1/3 of the cutting diameter.
• Make sure that fixed reducer rings are parallel to
each other.
• Handle saw blade with caution. They are ideally
stored in the originally package or special contain-
ers. Wear protective gloves in order to improve grip
and to further reduce the risk of injury.
• Prior to the use of saw blades, make sure that all
protective devices are properly fastened.
• Prior to use, make sure that the saw blade meets the
technical requirements of this saw and is properly
fastened.
• Only use the supplied saw blade for cutting wood,
never for the processing of metals.
• Use only a saw blade with a diameter that matches
the specifications on the saw.
• Use additional workpiece supports, if required for
workpiece stability.
• Workpiece support extensions must always be se-
cured and used during work.
• Replace table inlays when worn!
• Avoid overheating the saw teeth.
• When sawing plastic, avoid melting of the plastic.
Use the correct saw blades for the material to be cut.
Replace damaged or worn saw blades immediately.
When the saw blade overheats, stop the machine.
Allow the saw blade to cool down before using the
machine again.
• Use only saw blades that are marked with an equal
or higher rotational speed than the rotational speed
specified on the electric tool.
• Always ensure that the saw is stable and secure.
6.3 Laser beam
Attention: Laser beam
Do not look into the beam
Laser class 2
Protect yourself and you environment from
accidents using suitable precautionary measures!
• Do not look directly into the laser beam with unpro-
tected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reflecting sur-
faces and persons or animals. Even a laser beam
with a low output can cause damage to the eyes.
CAUTION
Methods other than those specified here
can result in dangerous radiation expo-
sure.
• Never open the laser module. Unexpected exposure
to the beam can occur.
• If the product is not used for an extended period of
time, the batteries should be removed.
• The laser may not be replaced with a different type
of laser.
• Repairs of the laser may only be carried out by the
laser manufacturer or an authorised representative.
6.4 Residual risks
The product has been built according to state-of-
the-art and the recognised technical safety rules.
However, individual residual risks can arise during
operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety Instruc-
tions" and the "Intended Use" together with the oper-
ating manual as a whole are observed.
• Do not load the product unnecessarily: excessive
pressure when sawing will quickly damage the saw
blade, which results in reduced output of the product
in the processing and in cut precision.
• When cutting plastic material, please always use
clamps: the parts which should be cut must always
be fixed between the clamps.
GB / IE / NI / CY / MT | 7