Dometic Coolair SPX1200T Guide De L'installation page 9

SPX1200T, SPX1200C, SPX1200I
The weights of the parking coolers totals are:
• SPX1200T: approx. 23 kg
• SPX1200I: approx. 15 kg
• SPX1200C: approx. 21 kg
1.2 Electrical requirements
• Battery capacity: min. 170 Ah for each battery.
To guarantee an optimal operating time, two batteries with 225 Ah each or
greater are recommended.
• Input voltage: between 20 V
1.3 Constructional requirements
Before installing the parking cooler, check whether any vehicle components
could be damaged or have their function impaired as a result of the installation,
see dimensions.
Dimensions:
• SPX1200T: fig. 1, page 3 and fig. 2, page 3
• SPX1200I: fig. 3, page 4
• SPX1200C: fig. 5, page 5
The maximum dimension refers to the contact face required for the seal. The min-
imum size refers to the diameter of the opening required.
For parking coolers with cover frame: The cover frame is screwed from below to
the air conditioner inside the cab. This requires a certain area of roof lining to be
available (see fig. 2, page 3 for SPX1200T Uni 2).
The angle of the installation area must be observed. The defined values apply to
the vertically and to the horizontally aligned unit.Larger tilt angles may cause
damage to the compressor. Where appropriate, the tilt of the unit can be
adjusted with spacer sleeves.
1.4 SPX1200T
The SPX1200T can only be installed in combination with the SPX1200C (com-
pressor unit). The requirements for installing the SPX1200C have to be observed
as well.
• Roof thickness (distance between contact faces of seals and cover frame):
48 – 90 mm
EN
Requirements for installation
and 30 V
9