Télécharger Imprimer la page

Dometic Coolair SPX1200T Guide De L'installation page 11

Masquer les pouces Voir aussi pour Coolair SPX1200T:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
SPX1200T, SPX1200C, SPX1200I
• The maximum length of the supply line between the exit of the truck's rear
wall and the compressor unit (lower input) is 2.1 m (fig. 0, page 7). In case
of shorter routes, the supply line must be fitted with a compensating bend. It
is impossible to trim the supply line.
• The available length of the 24 V connection cable measured from the lower
edge of the compressor unit is approx. 5.7 m.
If longer cables are required the cable extension has to be made by an
authorized workshop. The extension cable must have a cross section of
16 mm
1.6
SPX1200C
The SPX1200C can only be installed in combination with the SPX1200I or
SPX1200T(evaporator units). The requirements for installing the SPX1200I or
SPX1200T have to be observed as well.
• Dimensions: fig. 3, page 4
• Installation area without inclination to the front or back: fig. 4, page 4
Observe the following notes:
• The use of a vehicle-specific fastening frame is recommended for optimal
installation of the SPX1200C compressor unit to the cabin rear wall.
• Ensure you have enough room for installation on the cabin rear wall.
• Check if the retrofit might damage vehicle components, alter their shape or
impair their functionality.
• Avoid unnecessary and frequent mechanical impact on the supply lines
between the evaporator unit and compressor unit. Damage may lead to
refrigerant leakage and impaired system performance.
• Ensure the compressor unit is not mounted too low on the cabin rear wall.
Otherwise the heat emission from the engine may cause damage to the
system.
EN
2
.
Requirements for installation
11

Publicité

loading

Ce manuel est également adapté pour:

Coolair spx1200cCoolair spx1200i