Publicité
Les langues disponibles
Les langues disponibles
Water and Ice Dispensers
Follow the instructions for the hygienic safety of the water
dispensed.
� When using the refrigerator for the first time and every time the
filter is changed, it is recommended to let the water flow in the
circuit using the "Manual Cleaning" and discard the ice
produced in the first 24 hours.
� If the water dispenser has not been used for more than 4–
5 days, it is advisable to clean the circuit and run off the first
liter of water.
� Reposition the removable water dispenser (if present),
ensuring your hands are hygienically clean.
� Clean the ice drawer regularly by using only drinking water.
� The filter must be changed when indicated on the control panel
or when the ice/water dispenser has not been used for more
than 30 days.
� With each filter replacement, sanitize the ice and water
distribution system using a food grade disinfectant (with
sodium hypochlorite), which does not change the
characteristics of the materials. Rinse with at least 2 liters of
water before use.
� Only original spare parts supplied by the manufacturer should
be used when replacing components in the ice and water
dispenser.
� Any work on the refrigerator must be carried out by a qualified
technician or the After-sales Service.
� Clean water tanks if they have not been used for 48 hours;
flush the water system connected to a water supply if water
has not been drawn for 5 days.
� If the refrigerator is left empty for long periods, switch off,
defrost, clean, dry, and leave the door open to prevent mould
developing within the appliance.
Ice Maker
NOTE:
� If the ice is not used frequently is advisable to empty the ice
bin once every 8-10 days. It is normal that some ice cubes
stick to one another. If the ice is not frequently used, the older
cubes can become opaque, and will have a strange flavour
and become smaller.
� The Ice maker automatically deactivates if the Vacation
function is activated. When the Ice maker is started for the first
time, it is recommended to dispose of the first full bin of ice.
� If the equipment has been switched off for a month or more, it
is recommended to perform a water and filter cleaning cycle.
IMPORTANT: The ice maker will continue to operate even when
the ice bin is not in position.
� To activate the Ice Maker after installation of the appliance
touch the function icon and then and then the ice maker icon
from the functions.
� Allow 24 hours to produce the first batch of ice.
� The production is of 10 cubes per cycle and approximately
10 cycles in 24 hours.
� Output depends on the temperature set in the freezer, the
room temperature and the frequency of door opening.
� If the refrigerator is operating without being connected to the
water system, make sure that the Ice maker is deactivated.
� The Ice Maker produces ice until the ice tray is full and will
automatically stop once the maximum level is reached.
� With the SuperIce function, it is possible to increase the
quantity of ice produced a 24 hours, while the Set Cube Size
function permits selection of the size of the produced ice
cubes.
� The ice cube container should be cleaned occasionally with
warm water to prevent the odor. Make sure that you switch off
the ice maker before clearing the container. Rinse out and
wipe dry.
� Check the contents of the freezer for spoiled or out of- date
food. All odorous foods should be wrapped thoroughly or
stored in airtight containers to prevent the build-up of odors.
Operating noises
� Grumbling: refrigerator is running. Fan in the recirculating air
system is running.
� Bubbling, humming or gurgling noises: refrigerant is flowing
through the tubes.
� Clicking: motor is switching on or off. Solenoid valve on the
water connection is opening/closing.
� Rumbling: ice cubes are falling into the ice cube container.
IMPORTANT: Do not place any bottles or food for rapid cooling in
the ice cube container. The ice maker may become blocked and
be damaged.
23
Publicité
