Publicité
Les langues disponibles
Les langues disponibles
� Depth alignment: working from the inside of the drawer, after
lifting up the magnetic seal or rotating the cover plate where
necessary, adjust the panel position in the Z-direction by
adjusting the shoulder bolts and setscrews with the 4 mm hex
key in conjunction with each other finally locking each
mounting position in place.
A.
Adjustment Reglage
B.
Lock Blocage
� Attach the panel to the fixing devices starting from the top
aligning brackets.
� At this point, alignment between the panel and adjacent
cabinets can be adjusted using the alignment brackets and
small brackets.
� Vertical alignment: tighten or loosen the screw in the brackets
to raise or lower the panel.
20
� Depth alignment: working from the inside of the door, after
A
B
� To ensure proper ventilation for your refrigerator, allow for
� To avoid floor damage, make sure levelers are raised (not
� Attach anti-tip brackets (see page 8).
� Attach upper grill mounting brackets and upper grille.
� Insert one edge of each (B) 'Profile Trim Cover' into each of the
lifting up the magnetic seal on the handle side and rotating the
plastic covers on the hinge side, adjust the panel position in
the Z-direction by adjusting the shoulder bolts and setscrews
with the 4 mm hex key in conjunction with each other finally
locking each mounting position in place.
A.
Adjustment Reglage
B.
Lock Blocage
NOTE: Once the front panel has been adjusted, check that the
gasket has been repositioned correctly to assure the door/
drawer are closing correctly and avoid operational errors of the
unit.
5 mm of space behind the refrigerator to prevent overheating.
touching floor) and refrigerator is on rollers before moving.
(A) 'Profile Connection Trim' pieces and push firmly until a
'click' is heard. See image on top left of page 13.
A
B
Publicité
