Publicité
Les langues disponibles
Les langues disponibles
Maximum cabinet depth over "Integrated"
refrigerator with single door panel
It is possible to design a panel which will be the same for the
structure where refrigerator is going to be place and the cabinet
on the top of the same structure.
In this case, the total depth of the cabinet without the door (above
the refrigerator) must not exceed the total depth of the refrigerator
itself.
A.
1
7
/
" (47 mm) + front panel thickness
8
B.
23" (585 mm)
C.
25
5
/
" (650 mm)
8
This will allow the panel attached to the refrigerator door to open
correctly without interference during its rotation up to 105°.
Leveling
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
IMPORTANT: All four leveling legs must contact the floor to
support and stabilize the full weight of refrigerator. Rollers are for
moving the refrigerator, not for permanent support.
After moving the refrigerator to its final location:
1. Use a 11/16" (17 mm) socket driver to turn the leveling bolts
clockwise or counterclockwise to adjust the legs to the floor as
shown. The rollers should be off the floor.
2
1
2. Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinets.
3. Continue adjusting the leveling legs until the top of the
refrigerator is making contact with the bottom of the solid
soffit, or the bottom of the anti-tip boards, if anti-tip boards
were used. Do not crush the compressor cover.
IMPORTANT: Adjust in small increments to keep from damaging
the cabinet trim and causing problems with the door alignment or
top grille fit.
Install Base Grille
Grille assures ventilation which is placed in front lower portion of
the refrigerator.
If kickplate is present, then it must be designed to maintain
satisfactory air flow, as described in below drawing.
B
A
B
C
Total area is half of the kickplate area, so holes can be of any size
and shape.
For better air flow, advised to remove front grille of the refrigerator.
2
1
A
27
15
/
" (710 mm)
16
>4" (100 mm)
3/8" (10 mm)
C
C
21
Publicité
