Publicité
Les langues disponibles
Les langues disponibles
Figure 8 - Cross sectional view
A. 2X refer detail 'X'
C
B
Step '2'
A. Backside of panel
B. 3/4" (19.05 mm)
C. 3/4" (19.05 mm)
D. 1/4" (7 mm)
� Place the handle on top of the holes and insert the screws
through the washer, the panel, the standoff and into the
threaded receivers in the handle.
� Place firmly but do not over tighten as damage may occur to
the handle or the panel.
Install Door & Drawer Handles
Follow the below steps to install handles on doors and drawers:
� Insert the handle ends onto the supports already installed on
the door and the drawer.
� Tighten the Allen screws available on the handle.
IMPORTANT: The screws must be tightened by 1/8" (2.5 mm)
hex key or bit.
A
Detail 'X'
A
B
D
A
D
Step '3'
A. 3/4" (19.05 mm)
B. 3/4" (19.05 mm)
C. 1/4" (7 mm)
D. 5/16" (8.3 mm)
X
A
Attaching Door Panels and Bottom Drawer
NOTE: Once all brackets and handles are attached to the panels,
you can start installation of the bottom drawer.
Follow the instructions:
� Do not tighten fully tighten the screw to the receiver.
C
� Put the bottom drawer panel starting from the adjustment bolts
on the bottom.
� It is now possible to align panels to adjacent cabinets in height
using the lower alignment bolts and brackets, tightening or
untightening the screws into position as needed. With the
screw not fully tightened, move the panel sideways manually
to align it to the other panels on the unit or other adjacent
structures.
Set the bottom adjustment bolts using the lock nut once you
are happy with the height alignment.
19
Publicité
