Télécharger Imprimer la page

Jennair JBBFL30NMX Manuel D'utilisation page 10

Masquer les pouces Voir aussi pour JBBFL30NMX:

Publicité

Les langues disponibles

Les langues disponibles

Unpack the Refrigerator
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
Remove the Packaging
Dispose of/recycle all packaging materials. Do not use sharp
instruments, rubbing alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These products can damage the
surface of your refrigerator. For more information, see
"Refrigerator Safety."
Refrigerator is attached to the packaging base with four bolts.
Follow the below steps to release the refrigerator from base.
B
A
C
1. Unscrew the four bolts (A) by using 3/4" (19 mm) wrench.
2. Unscrew the rear wheel adjusting bolt (B) to release the fixing
bracket (C) by using 3/4" (19 mm) wrench.
3. Remove the screws (E) to release the fixing bracket (D).
4. Remove the fixing brackets (C) and (D).
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the floor with cardboard or
hardboard to avoid floor damage. Always pull the refrigerator
straight out when moving it. Do not wiggle or "walk" the
refrigerator when trying to move it, as floor damage could occur.
IMPORTANT: All four leveling legs must contact the floor to
support and stabilize the full weight of the refrigerator.
Clean Before Using
After you remove all of the package materials, clean the inside of
your refrigerator before using it. See the "Cleaning" section in this
manual.
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when they
are cold. Shelves and covers may break if exposed to sudden
temperature changes or impact, such as bumping. Tempered
glass is designed to shatter into many small, pebble-size pieces.
This is normal. Glass shelves and covers are heavy. Use both
hands when removing them to avoid dropping.
10
E
D
A
Move the refrigerator to the installation structure.
Main Components
C
1
2
3
4
A
6
7
B
5
A.
Refrigerator
B.
Freezer Compartment
C.
Top Front Protection Grill
1. Galvanized painted body
2. Interactive control panel
3. Water filter (*)
4. Adjustable shelves
5. Drawers in freezer compartment
6. Drawers refrigerator compartment
7. Ice maker container (*)
8. Door bins
9. LED illuminations for the freezer compartment bottom drawer
10. Freezer bottom drawer compartment convertible into
refrigerator compartment
11. Removable grill condenser
(*) on models with Ice Maker
Connect the Water Supply
Read all directions before you begin.
IMPORTANT:
� Plumbing shall be installed in accordance with the
International Plumbing Code and any local codes and
ordinances.
� The gray water tubing on the back of the refrigerator (which is
used to connect to the household water line) is a PEX
(crosslinked polyethylene) tube. Copper, stainless steel
braided and PEX tubing connections from the household water
line to the refrigerator are acceptable, and will help avoid
off-taste or odor in your ice or water. Check for leaks. If PEX
tubing is used instead of copper.
8
9
10
11

Publicité

loading