Publicité
Les langues disponibles
Les langues disponibles
Grille is attached with refrigerator by means of magnetic plates
which will help in removal and regular cleaning operations for
customer.
NOTE: Air inlet and outlet must not be blocked and condenser
must be cleaned on regular basis.
A.
4" (100 mm)
Complete Installation
1. Remove the label after the installation is done.
2. Turn the water supply line valve to the "Open" position.
3. Turn the refrigerator switch to the ON position. See "Power
On/ Off Switch" in the Use & Care Guide for instructions. Wait
a few minutes. Check the water line connections for leaks.
4. Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the "Cleaning" section in the
Use & Care Guide for instructions. Remove the film and
cardboard from the grille and doors or door frame, depending
on your model.
5. Install the shelves and bins in the refrigerator and freezer
compartments.
6. The controls are preset at the factory to the midpoint setting.
Check that the compressor is operating properly and that all
the lights are working.
7. Flush the water system before use. See "Water System
Preparation."
22
A
B
A.
Label
B.
Door
REFRIGERATOR FEATURES
Operating Your Refrigerator
How to use the refrigerator with electronic control
Your refrigerator is equipped with a cutting-edge and user-friendly
electronic temperature control located on the front panel of the
refrigerator door.
Date
The display will show the date in the format
(day:month:year).
By touching the display you can modify the
settings.
Time
The display shows the hours and minutes in the
format hh:mm.
This function selects the display at 12 hours or
24 hours.
Celsius or Fahrenheit degrees
This function permits visualizing the
temperature in Centigrade or Fahrenheit
degrees. Normally, the refrigerator is set for
visualization in centigrade degrees.
Language
To set the language of the refrigerator, simply
touch the settings button on the display.
Reset
It gives the possibility to restore the base
settings that were set in the factory, cancelling
all the changes that has been made from there
onward.
Demo Mode
It is possible to simulate the functioning of the
refrigerator, for showroom display or for fairs.
Demo Mode function works when the
compartments are at the set temperatures.
Maintenance
Units requires, for a correct operation, the
cleaning of the ventilation grille, of the filter and
the condenser. The default setting of the unit is
"Warning disabled".
Service
The service function is reserved for the
assistance.
Info System
The function Info System shows the data of the
products for example the software's code, serial
number and the factory's codes of the
refrigerator.
Publicité
