Télécharger Imprimer la page

Jennair JBBFL30NMX Manuel D'utilisation page 12

Masquer les pouces Voir aussi pour JBBFL30NMX:

Publicité

Les langues disponibles

Les langues disponibles

1. One end of the bungee is connected to the power supply
cable by means of a clamp.
2. During assembly the power supply cable and its bungee are
clamped and housed in the lower left.
3. During installation, remove the cable and its bungee from the
housing.
4. Connect the free end of the bungee to the top screw of the
body.
5. The electrical cable can now be supported avoiding getting
caught on the wheels, avoiding pulling the electrical cable
damaging it and facilitating the installation of the equipment in
the recessed niche and enclosure.
6. Plug into a grounded 3–prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice.
Discard the first three batches of ice produced. Allow 3 days to
completely fill the ice storage bin.
7. Flush the water system. See "Water and Ice Dispensers."
Move Refrigerator To Final Location
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is completely
installed.
Use two or more people to move and install refrigerator.
Failure to do so can result in death or serious injury.
Built-in Installation Single Refrigerator
For a built-in installation, special side profiles are installed
between refrigerator and adjacent cabinets.
For installation follow the steps:
� There are 2" x 2" x 1/4" spacers (x10) secured to the
refrigerator with 2 screws that need to be left on the unit at
each location intended for the 'Profile Connection Trim' (x10)
pieces. Remove the screw from each spacer (x10) closest to
the front of the refrigerator and use those screws to attach the
(x10) 'Profile Connection Trim' pieces to the 'Appliance. DO
NOT OVERTIGHTEN.
12
Side Profiles Mounting:
A
A.
Profile Connection
Trim
B.
Profile Trim Cover
C.
Appliance
D.
Wall of Furniture
� Place the refrigerator into the installation structure.
Use the (x10) screws supplied in the installation packet, to go
through the Profile Connection Trim (x10) pieces attached to
the refrigerator, to secure the refrigerator to the (D) 'Wall of
Furniture'.
E
B
A
A.
Profile Connection Trim
B.
Profile Trim Cover
C.
Appliance
D.
Wall of Furniture
B
B
D
E
B
D
C
A
B
B
D
C
A

Publicité

loading