Publicité
Les langues disponibles
Les langues disponibles
Drawer Panel
� When preparing the Drawer Panel, follow the same
instructions as per the door panel, but make sure
measurements are taken starting from the top edge.
The height-adjustment support brackets are oriented the
opposite way.
� Prepare the refrigerator door (and drawer(s) if applicable) for
panel mounting by threading the shoulder bolts into the
recessed receivers and the set screws into the other hole.
Ensure the end with the hex key socket is threaded into the
door and not on the visible end. Thread this in far enough that
it is flush with refrigerator door face so as not to interference
with hanging the panel. You will adjust these later from the
inside of the door and drawer.
✝TORX and T30 are trademarks of Acument Intellectual Properties, LLC.
*Numbers may vary depending on refrigerator model and handle type.
Attaching Door Handles
NOTE: Handles will have to be mounted on the panels before they
are applied to the refrigerator.
Follow the instructions:
� Drill two holes on the back of the panels.
� Depending on the style of panel, it may be necessary to create
tapered countersinks for the screw heads.
NOIR™ Style Door Handle
BEFORE YOU BEGIN: The handle and handle mounting
hardware must be installed before installing the custom wood
panel. A qualified cabinet maker must perform the installation.
IMPORTANT:
� This kit is designed to be used only with custom wood
panels with thickness of 3/4" (18 mm) to 1
� To avoid handle damage, lift the door and drawer panel(s)
by the edges.
TOOLS NEEDED: Gather the required tools and parts before
starting installation. Read and follow the instructions provided
with any tools listed here.
� Tape measure
� Pencil
� Cordless drill
� 1/4" Drill bit
� 11/32" Drill bit
PARTS SUPPLIED WITH HANDLE:
� Handle - freezer drawer
� Screws - 1/4-20 x 0.791"
Install the Refrigerator Handle(s)
IMPORTANT:
� Verify panel dimensions before drilling any holes.
� For hole locations and the spacing requirements of NOIR™
handle mounting, refer Figure 1.
NOTE: Figure 1 represents a Side by Side (left) freezer panel,
a French door (left) refrigerator panel, a bottom mount left
swing refrigerator panel, and column refrigerator/freezer panel.
Mirror the hole pattern on the opposite door panel as required.
1. Mark the hole locations as shown in Figure 1.
2. Clearance is required for the handle fasteners on the back
side of the panel. Flip the panel over to reveal the backside
of the panel. Using a 3/4" forstner bit, drill a 9/32" (7 mm)
deep counterbore at the top and bottom hole locations as
shown in Figure 2 - Detail X.
3. Drill a 5/16" (8.2 mm) holes at the top and bottom locations
shown in Figure 2 - Detail X.
1
/
" (28 mm).
8
� 3/4" forstner bit
� Torx T30
✝
bit
� 11/32" socket driver
� Torque Wrench
� Handle - refrigerator
door
*
� Hex nuts - #8-32 x 0.124"
15
Publicité
