Selve SE Pro Notice De Réglage page 28

GB
Setting of the end positions
4. Setting of the end positions
4.1. Delivery status
In the SELVE delivery status no end positions or transmitters are programmed into
the motor! In this state, the motor can be operated in deadman's operation only.
Safety functions such as obstacle detection are deactivated at delivery and will only
become active after both end positions are set.
The SE Pro motor is in automatic setup-mode.
4.2. Mechanic requirements
Operating of the SE Pro motor is possible with normal safety and fixing springs. Option-
ally, security springs can also be used (manual setup-mode).
If the motor is supposed to move against the stop in the upper end position, a stable
end stop must be installed!
If the motor is set in automatic setup-mode, a limit must be installed for the lower
switch-off position (e.g. windowsill) for the shutter to run against.
4.3. Setup functions
The end positions setting of a SELVE motor is possible via:
• any standard switch (in automatic mode)
• the setting switch for electronic motors (item no. 290103, manual setup-mode)
28