Selve SE Pro Notice De Réglage page 24

GB Information about the motor features
2. Information about the motor features
2.1. Designated use
The motor type SE Pro must only be used for operating roller shutters.
2.2. Properties
To protect the hanging, the motors have an obstacle detection system after the limit
position setting in the downwards direction with a reversing function and a self-teach-
ing overload detection in the upwards direction.
The obstacle detection of the drives has been developed to protect the roller shutter
construction against damages.
Since, depending on the position of the hangings, when an obstacle is detected, the
entire hanging weight may have to be stopped before the object detection system trips,
do not use the motor's obstacle detection system for personal protection.
The stability of the roller shutter system has to be suitable for the permanent use of the
drive.
For the installation with blocking springs or burglar proof fixations the manual setting
of the lower end limit is recommended. SE Pro drives may only be used at one-part
constructions.
The drive is suitable for left and right installation controlled with conventional switches,
buttons and control systems that are suitable for roller shutter and sun control drives.
The drive torque has to be chosen correctly for the hanging weight. Parallel connection
of several drives is possible (please observe the capacity of the switching elements!).
The airborne noise of the motor is significantly below 70 dB (A). Depending on the type
of the roller shutter/awning/screen a strengthening of the sound intensity of the motor
is possible. It can be reduced by use of appropriate measures (e.g. insulation of the
box, using noise protection plugs, etc.).
24