Intended Use; Basic Safety Information - Burkert SE30 Ex Manuel D'utilisation

attention
Warns against a possible risk.
• Failure to observe this warning can result in substantial
or minor injuries.
atex
Indicates ATEX important information or safety
instructions.
note
Warns against material damage.
• Failure to observe this warning may result in damage
to the device or system.
Indicates additional information, advice or
important recommendations.
Refers to information contained in this manual or in
other documents.
→
Indicates a procedure to be carried out.
Definition of the word "device"
The word "device" used within this manual refers to the
electronic flowmeter type SE30 Ex.
English
4
3.

bASic SAfETy informATion

This safety information does not take into account:
• any contingencies or occurences that may arise during
installation, use and maintenance of the devices.
• the local safety regulations that the operator must ensure
the staff in charge of installation and maintenance observe.
danger due to high pressure in the installation.
danger due to electrical voltage.
danger due to high temperatures of the fluid.
danger due to the nature of the fluid.
various dangerous situations
To avoid injury take care:
• to prevent any unintentional power supply switch-on.
• to ensure that installation and maintenance work
are carried out by qualified, authorised personnel in
possession of the appropriate tools.
English
6
2.

inTEnDED uSE

use of the device that does not comply with the
instructions could present risks to people, nearby
installations and the environment.
• The SE30 Ex electronic flowmeter is intended for
measuring the flow rate in neutral or slightly aggressive
liquids that have no solid particles, in explosive areas
(see chap. 6).
• This device must be protected against electromagne-
tic interference, ultraviolet rays and, when installed
outdoors, the effects of climatic conditions.
• This device must be used in compliance with the
characteristics and commissioning and use conditions
specified in the contractual documents and in the
operating instructions.
• Requirements for the safe and proper operation of the
device are proper transport, storage and installation,
as well as careful operation and maintenance.
• Only use the device as intended.
→
Observe any existing restraints when the device is
exported.
various dangerous situations
To avoid injury take care:
• to guarantee a set or controlled restarting of the pro-
cess, after a power supply interruption.
• to use the device only if in perfect working order and
in compliance with the instructions provided in the
operating instructions.
• to observe the general technical rules when installing
and using the device.
• not to use the device for the measurement of gas flow
rates.
• not to use fluid that is incompatible with the materials
the device is made of.
• not to use this device in an environment incompatible
with the materials it is made of.
• not to subject the device to mechanical loads (e.g. by
placing objects on top of it or by using it as a step).
• not to make any internal or external modifications to the
device.
English
5 5
English
7 7