Publicité
Les langues disponibles
Les langues disponibles
Connecting external
dust extraction
Connecting external dust
extraction:
1. Slide the adapter for external dust
extraction (19) as far as it will go into
the guide rail between the device and
baseplate (4).
2. Connect an approved dust extractor
(not included in delivery) to the adapter
for external dust extraction.
3. If the external dust extractor does not
fit, use the additional reducer (20) if
necessary.
Removing the external dust
extraction:
1. Disconnect the suction tube from the
adapter for external dust extraction
(19).
2. Disconnect the adapter for external
dust extraction (19).
Plunge cuts
Plunge cuts may only be made in soft ma-
terials such as wood, aerated concrete,
plasterboard, etc. However, this requires a
certain amount of practice and is possible
only with short saw blades.
Plunge cuts are only allowed if the mitre
angle is 0°.
1. Place the front edge of the baseplate
onto the workpiece surface.
2. Switch the saw on.
3. Slowly saw at an angle into the work-
piece, then bring the saw into a verti-
cal position.
4. Continue sawing along the cutting line.
5. Turn off the saw and lift it off the work-
piece after finishing work.
Working instructions
• Clamp the workpiece. Use a clamping
device for small workpieces.
• Draw a line to specify the direction in
which the saw blade is guided.
• Hold the device securely by the handle.
• Set the sawing speed.
• Adjust the mitre angle.
• Set the pendulum stroke position.
• Turn on the device.
• Wait until the device has reached full
speed.
• Place the bottom plate (4) on the work-
piece.
• Slowly move the device along the
marked line, pressing the bottom plate
firmly against the workpiece.
• Do not apply too much pressure to the
device. Let the device do the work.
• Before shutting down the device, switch
it off and wait for it to come to a com-
plete standstill.
Cleaning and Servicing
Switch off the device and re-
move the battery before car-
rying out any maintenance
work.
You should have any repair and
maintenance work that is not de-
scribed in these instructions carried
out by our Service Centre. Only use
original parts.
Cleaning
The device must not be
sprayed with water or placed
in water. Otherwise there is
a risk of electric shock.
GB
IE
31
Publicité
