Télécharger Imprimer la page

Parkside 359694 2101 Traduction Des Instructions D'origine page 29

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
Recharging the battery
Allow a hot battery to cool before
charging.
1. Remove the battery (23) from the appli-
ance, as necessary.
2. Insert the battery (22) in the charging
compartment of the battery charger (25).
3. Plug the battery charger (25) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (25) from the
mains.
5. Remove the battery (23) from the
charger (25).
Installing/changing the
saw blade
Wear protective gloves when
attaching the saw blade.
Risk of injury when touching the
saw blade.
Only saw blades with a
T-shank mount (single lug
shank) such as the supplied
saw blades (15/16) can be
used.
Installing the saw blade
Make sure that the saw blade holder is
free of splinters or other material residue.
1. Turn the chuck (9) as far forward as
possible and hold it firmly in this posi-
tion.
2. Insert the saw blade (15/16) into the
chuck (9). When inserting the saw
blade (15/16), make sure that the
back of the saw blade is in the notch
of the guide roller (8). Make sure that
the saw blade (15/16) is attached cor-
rectly and the teeth are pointing in the
cutting direction.
3. Release the chuck (9).
Be sure to always use the correct
saw blade for the material.
Removing the saw blade
1. Hold the saw blade (15/16) firmly.
2. Turn the chuck (9) as far forward as
possible and hold it firmly in this posi-
tion.
3. Remove the saw blade (15/16) from
the chuck (9).
4. Release the chuck (9).
Removing/attaching the
parallel guide
The parallel guide can be fitted on
both sides of the device.
Attaching the parallel guide
1. Loosen the retaining screws (11) if nec-
essary.
2. Slide the parallel guide (18) through
the slide-in openings (10).
3. Retighten the retaining screws (11).
Removing the parallel guide
1. Loosen the retaining screws (11).
2. Pull the parallel guide (18) out of the
slide-in openings (10).
Removing/attaching the
tension tear protection
Removing the tension tear protection
1. Press the tension tear protection (22)
away from the recess in the slide shoe
(21).
GB
IE
29

Publicité

loading

Ce manuel est également adapté pour:

Pstka 12 b3