SilverCrest 341821 2001 Mode D'emploi page 48

Inserting the espresso sieves in the sieve holder
1) Place the large s or the small espresso sieve d in the sieve holder p:
–
Make sure that the small indentation on the large s or small espresso
sieve d lies on the indentation on the sieve holder p when you put it in.
–
Then turn the large s or small espresso sieve d a little so that it cannot
fall out.
NOTE
► Do not remove the used espresso sieve s d until it has cooled down!
► To remove the espresso sieve s d from the sieve holder p turn the
espresso sieve s d until the indentation on the espresso sieve s d is
over the indentation on the sieve holder p. You can now remove the
espresso sieve s d.
SEMM 1470 A2
GB │ IE │
45 ■