SilverCrest 341821 2001 Mode D'emploi page 47

Operation
Filling the water tank
NOTE
► Use only fresh drinking water to prepare espresso/cappuccino/latte
macchiatto.
1) Remove the water tank lid t and pull the water tank z upwards and out
of the appliance.
2) Fill it with water to at least the Min marking. Never fill it with more water
than up to the Max marking.
3) Push the water tank z back onto the appliance. Ensure that the water tank
z clicks back into place on the appliance.
4) Put the water tank lid t back on.
Filling the milk tank
If you want to prepare drinks that contain milk froth, such as cappuccino or latte
macchiato, you must fill the milk tank 6 with milk.
NOTE
► You can use cow's milk or soy milk in this appliance.
1) Tilt the milk tank 6 lightly upwards and, at the same time, pull it upwards
and forwards out of the appliance.
2) Take off the milk tank lid 4.
3) Fill it with milk to at least the Min marking. Never fill it with more milk than
up to the Max marking.
4) Replace the milk tank lid 4 on the milk tank 6.
5) Push the milk tank 6 back into the appliance so that it clicks into place.
NOTE
► After preparing your drink, if you want to keep the milk in the milk tank 6,
put the milk tank 6 into the refrigerator for storage.
NOTE
► If the milk tank 6 is not in place or not properly inserted, both of the
espresso control lamps 1/r light up. This shows that you can only
prepare espresso, as this does not require any milk.
│ GB │ IE
■ 44 SEMM 1470 A2