SilverCrest 341821 2001 Mode D'emploi page 59

"Large" latte
–
Press and hold the "Large" latte button 3
the pump starts to work. Milk froth comes out of the milk nozzle 0.
–
Once the desired quantity of milk froth has been produced, stop milk
froth production by pressing the "Large" latte button 3
can set a duration of 5–90 seconds.
–
Following the milk froth production, the espresso comes out of the
espresso outlet q to prepare the latte macchiato.
–
The next time you prepare a latte macchiato using the "Large" latte
button 3
output.
Frothed milk
You can also produce only frothed milk, for instance, to make hot chocolate.
1) Fit the sieve holder p.
2) Ensure that there is enough milk in the milk tank 6. Add more milk if
necessary.
3) Place a suitable cup on the drip grille 8. If you are using a small container,
pull out the tray for small cups 9 and place the container on it.
4) Set the milk nozzle 0 so that it is pointing into the cup.
5) Switch the appliance on using the on/off switch i and wait until all control
lamps light up permanently. The appliance has now heated up.
6) Press the "Large" cappuccino button 2
for the "Small" cappuccino button e
"Large" cappuccino button 2
the milk nozzle 0.
7) Stop the milk output by pressing any button. The milk will stop coming out
automatically after 70 seconds.
8) Switch the appliance off using the on/off switch i.
9) Clean the appliance as described in the section "Cleaning and Care".
│ GB │ IE
■ 56
the newly programmed duration will be used for milk
light up and frothed milk comes out of
for about 3 seconds until
again. You
2x in a row. The control lamp
and the control lamp for the
SEMM 1470 A2