SilverCrest 341821 2001 Mode D'emploi page 58

12) Switch the appliance off using the on/off switch i.
13) Clean the appliance as described in the section "Cleaning and Care".
For hygienic reasons, the milk tank 6, the milk tank lid 4 and the milk
nozzle 0 must be cleaned thoroughly after every time you make milk froth.
Failure to do so will affect the quality of the milk froth and may lead to the
formation of germs!
NOTE
► If you do not turn off the appliance with the on/off switch i, the appliance
will switch itself into power saving mode automatically after approx.
15 minutes if no other button is pushed. If you want to make another drink,
simply press any button. The appliance heats back up.
Changing the duration of the milk froth output
NOTE
► You can adjust the amount of the milk froth by turning the "Milk quantity"
knob 5 and also the duration of the milk output. The further you turn the
"Milk quantity" knob 5 toward " " the more milk/milk froth will come out
of the milk nozzle 0 during the same amount of time. Make sure you do
not turn the "Milk quantity" knob 5 further than the " " marking.
Otherwise you will be in cleaning mode (see section "Cleaning and care").
You can customise the duration of the milk froth output for the programmes
"Small latte" and "Large latte".
"Small" latte
–
Press and hold the "Small" latte button w
the pump starts to work. Milk froth comes out of the milk nozzle 0.
–
Once the desired quantity of milk froth has been produced, stop milk
froth production by pressing the "Small" latte button w
can set a duration of 5–70 seconds.
–
Following the milk froth production, the espresso comes out of the
espresso outlet q to prepare the latte macchiato.
–
The next time you prepare a latte macchiato using the "Small" latte
button w
output.
SEMM 1470 A2
the newly programmed duration will be used for milk
for about 3 seconds until
again. You
GB │ IE │
55 ■