Gaggenau 400 Serie Notice D'utilisation page 17

Fault
After the drying proce-
dure, the appliance dis-
plays the ¢ and ...
symbols.
The vacuum in the plas-
tic bag is not retained.
The lid cannot be
opened.
Error
The bag is bad.
The heat-sealed seam
is bad.
Causes
One drying cycle alone was not
sufficient.
Sharp parts of the food (for
example bones) may poke holes
in the bag.
The heat-sealing time you have
selected is unsuitable for the
plastic from which the bag is
made.
There is liquid, grease or crumbs
along the heat-sealed seam. The
bag has creases along the heat-
sealed seam.
A slight vacuum has formed and
it is holding the lid closed.
Before Calling for Service
Possible remedy
Wait until the ... symbol is no
longer lit up. Then start another
drying cycle.
Check the bag for damage. Use a
different bag if it is damaged. If
the damage is caused by sharp-
edged parts of the food, as far as
possible, position these in the
bag in such a way that they can-
not damage the wall of the bag.
Select a different heat-sealing
time.
Make sure that the bag is dry,
that it has no creases, and that it
is positioned fully on the heat-
sealing bar.
Use a different bag. Fold over
the edge of the bag by 1¼ in
(3 cm) before you fill it.
Do not use force or tools to open
it. Initiate vacuum-sealing again
and then cancel it immediately.
Disconnect the appliance from
the power supply. Wait
30 seconds and then start up the
appliance again.
Touch the ÿ symbol for more
than 5 seconds. The system is
reset.
en-us
17