FUXTEC FX-MHP245 Mode D'emploi page 43

Then operate the throttle lever (Figure 1, point a) so that the choke lever
automatically returns to the open position and release the throttle lever again. Then
pull the starter cable until the engine runs.
IMPORTANT!
Do not pull the starter cable all the way to the end and do not let it spring back
-
by releasing the knob. This could lead to starter errors.
Push the choke lever down to open the choke. (F3)
-
Let the Engine warm up for a few minutes before starting work.
-
NOTE
3. if the Engine is to be restarted immediately after switching off, the choke must be
left open (F3)
4. too much choke can lead to starting problems due to overly excessive fuel flow. If
the Engine cannot be started after several attempts, open the choke and pull the
starter cable repeatedly or remove the spark plug and dry it.
STOPPING THE ENGINE
1. release the throttle valve lever and let the Engine run for half a minute
2. move the ignition switch to the "0"(STOP) position
NOTE
If the Engine does not stop after switching off, close the choke so that the Engine stops
after a while.
IMPORTANT
During the first 20 hours of operation, the hedge trimmer should not be used at full
power for long periods.
ADJUSTING THE IDLE SPEED
- Before adjusting the carburettor, clean the air filter and run the engine warm.
- The idle limiting screw is adjusted so that there is a sufficient safety margin between
the idle speed and the engagement of the clutch.
Original User Manual FUXTEC FX-MHP245_de_en_fr_ita_rev1
43