FUXTEC FX-MHP245 Mode D'emploi page 42

20. Starting/stopping the device
STARTING THE ENGINE
WARNING!
The cutting blade starts to move when the Engine is started.
1. Release the throttle lever and make sure it is fully down. (Picture 1, point a).
2.Set the on/off switch to "I" (figure 1, point b).
3.Press the primer pump several times until fuel flows into it. (Q)
4. Move the choke lever to the closed position. (b)
5. place the equipment on a flat, solid surface. The cutting head must remain free
and must not encounter any obstacles.
6. hold the equipment firmly and pull the starter cord quickly and firmly until the
Engine responds (2-3 strong pulls).
7. IMPORTANT: Engine has not started (it only indicates that it wants to start).
Original User Manual FUXTEC FX-MHP245_de_en_fr_ita_rev1
42