FUXTEC FX-MHP245 Mode D'emploi page 51

The distance between the upper and lower shearing blades does not need to be adjusted, as this
product, due to its design, always guarantees an optimal distance when assembled correctly.
System/Component
Fuel leaks, fuel
splashes
Fuel tank, air filter,
fuel filter
idling adjustment
screw
Spark plug
Cylinder fins, air
intake opening
muffler, spark extinguisher,
cylinder outlet
throttle valve lever,
ignition switch
cutting parts
Gearbox housing
Screws/nuts/bolts
Maintenance before long-term storage
IMPORTANT!
When draining the fuel, avoid spilling the fuel. Spillage must be removed and the lid of the
container closed tightly.
1. Have the engine run with an empty fuel tank until it stops on its own to remove any
remaining fuel in the engine
2. Remove the spark plugs and pour 1-2cc of two-stroke engine oil into the engine. Pull the
pull starter 2 - 3 times. Then reinstall the spark plugs.
Original User Manual FUXTEC FX-MHP245_de_en_fr_ita_rev1
Procedure
Wipe
check/clean
Check idle
speed
Clean and
readjust
cylinder gap
clean
clean
Check function
replace if
something is
not correct
Lubricate
tighten/replace
Befor After After
e use every 25 every 50
hours hours
X
X X
X
X
X
X
X
X
51
After Note
every
100
hours
Replace if
necessary
Replace
carburettor, if
necessary
GAP: 0.6 - 0.7 mm
Replace if
necessary
X
X
not the adjusting
X
screws