FUXTEC FX-MHP245 Mode D'emploi page 45

USE:
For easy trimming of hedges, the handle can be turned 90° to the right or left.
Do not operate the throttle during this procedure!
Proceed as follows:
1. Release the handle by pressing the locking lever (2).
2. Turn the grab handle until the locking lever audibly engages.
3. When the grab handle is locked in its new position, the throttle lever can be operated
again.
4. only use as much gas as the use of the equipment requires. excessive Engine speeds
are not necessary.
Avoid cutting thicker branches as this may damage the cutting blades and
-
shorten the life of the power system.
If the equipment is held at an angle of 5-10° to the object to be cut, the work
-
can be done more easily and the cutting will be more attractive.
Always hold the body on the carburettor side of the equipment, never on the
-
exhaust side.
When a new piece of equipment is used for the first time, grease may leak out of
-
the gear case during the first few minutes. Since this is excess grease, there is
no reason for concern. Just wipe it off when you stop the equipment again.
Original User Manual FUXTEC FX-MHP245_de_en_fr_ita_rev1
45