FUXTEC FX-MHP245 Mode D'emploi page 50

10. EXHAUST PORT
a. Remove the muffler and use a screwdriver to remove carbon deposits from the exhaust
port. Also remove carbon deposits from the exhaust port and cylinder exhaust port.
(1) Screwdriver
(2) Exhaust silencer
b. Retighten screws, bolts and brackets.
c. Check that no oil or grease has come between the clutch lining and the clutch drum and
clean with oil and lead-free petrol if necessary.
11. TIGHTENING
When attaching the blade, make sure to secure the spacer, washer and screw, then tighten the
nut.
(1) Screw
(2) Spacer
(3) Nut
Check the blade and fasteners for tightness, cracks or bending.
-
Check the cutting edges and sharpen them with
-
a flat file at a 45° angle.
Keep the cutting edges sharp.
-
Round off the back.
-
Do not grind with water.
-
Original User Manual FUXTEC FX-MHP245_de_en_fr_ita_rev1
50