Preparing Trimmer For Operation; Assembling The Trimmer; Mounting The Loop Handle - Stihl FSA 130 R Notice D'emploi

English
► Pull the connecting cable plug out of the
socket.
► Store the trimmer in a clean and dry condition.

5 Preparing Trimmer for Operation

5.1 Preparing Trimmer for Operation
Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– Trimmer, @ 4.7.1.
– Deflector, @ 4.7.2.
– Mowing head, @ 4.7.3 or metal cutting attachment,
@ 4.7.4.
– Battery as described in the STIHL AR battery's
instruction manual or in the user instructions for the "AP
belt bag with connecting cable".
► Check the battery as described in the STIHL AR battery's
instruction manual or in the user instructions for the "AP
belt bag with connecting cable".
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
► Clean the trimmer, @ 15.1.
► Mount the loop handle, @ 6.1.
► Select combination of cutting attachment, deflector and
carrying system, @ 20.
► Mount the deflector, @ 6.3.1.
► If you are using a universal deflector together with a
mowing head: Remove the skirt and line limiting blade,
@ 6.4.1.
► If you are using a metal cutting attachment: Mount loop
handle with barrier bar, @ 6.2.1.
► Mount mowing head or metal cutting attachment, @ 6.5.1
or @ 6.6.1.
46
► Put on and adjust the STIHL AR battery, carrying system
or "AP belt bag with connecting cable", @ 7.
► Balance the trimmer, @ 7.4.
► Adjust the loop handle, @ 7.5.
► Check the controls, @ 10.1.
► If 3 LEDs on the battery flash red while you are checking
the controls: Pull connecting cable plug out of the
socket and contact your STIHL dealer for assistance.
There is a malfunction in the trimmer.
► If you cannot carry out this work: Do not use your trimmer
and contact your STIHL dealer for assistance.

6 Assembling the Trimmer

6.1

Mounting the Loop Handle

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the drive tube
(5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle (3) and
clamps (4 and 6).
5 Preparing Trimmer for Operation
3
4
5
0458-725-9921-A