Publicité
IMPORTANT SAFETY
INSTRUCTIONS
• Take care when using this machine
near the top of stairs to avoid loss of
balance.
• DO NOT cover the machine when in use.
• DO NOT run the machine dry as this
could damage the floor surface and/or
the machine itself.
• DO NOT leave the machine running
unattended.
• Keep hair, loose clothing, hands, feet,
and all other parts of the body away from
openings and moving parts. Do not put
hands under base as rotating parts can
cause injury.
• DO NOT put any object into openings. DO
NOT use with any opening blocked. Keep
free of dust, debris and anything that may
reduce airflow.
• DO NOT use volatile or combustible
solvents (e.g., diesel, petrol, PA,
trichloromethane) nor any corrosive, toxic,
or highly irritant substance to wash floors,
even if diluted. In the event of accidental
contact with any such substances (e.g.,
due to spills) follow the decontamination
procedures in force at the user site. If
in any doubt about the condition of the
machine, contact Tornado or the dealer/
agent who supplied the machine.
• DO NOT leave the machine unattended
when plugged in. Switch Off when not
in use and before changing brushes
or attempting any maintenance or
adjustment.
SAVE THESE INSTRUCTIONS
• DO NOT fill the machine with water
hotter than 104°F (40°C).
• When used on escalators, ensure the
machine is positioned at the bottom
of the escalator with the escalator
moving towards the operator.
• DO NOT pull or carry charger by cord, use
cord as a handle, close a door on the cord,
or pull cord around sharp edges or corners.
• DO NOT run machine over cord. Keep
cord away from heated surfaces.
• DO NOT unplug by pulling on cord. To
unplug, grasp the plug, not the cord. Do
not handle plug or machine with wet hands.
Turn off all controls before unplugging.
• Connect only to a properly grounded
outlet. See grounding instructions.
• Use care to keep electrical supply
cable from contacting moving parts
such as floor brushes.
• Make sure voltage and frequency at
the wall receptacle correspond with
that indicated on nameplate before
plugging in machine.
• The machine must be kept clean and in
good condition. If any parts are damaged,
they shall only be replaced by an approved
part by the manufacturer, its service agent
or a similar qualified person in order to
avoid a hazard.
• Only replace the power cord with original
OEM equipment.
4
Publicité
