Publicité
ASSEMBLY
Splash Guard Assembly
The two splash guards have to be assembled onto the brushes base group. Insert
the metal strips inside the slots on the rubber. Place the round hole at the flat
extremity of the strip onto the screw placed in the front of the cover. Secure the
strips with the nut.
Screw down the knobs in the rear part of the cover in the free end of the metal
strips. The operation has to be carried out for each splash guards. With the brushes
assembled, the splash guard must slightly touch the floor.
Brushes Assembly
To assemble the brushes, proceed as follows:
1. Switch on the machine turning the key (1) clockwise.
2. Press the push button (2) of up/down of the brushes base to lift the brushes.
3. Switch the machine OFF by turning the key (1) counterclockwise.
16
Publicité
