General and safety information
EN
for the specialist company
for the user
1.5 Intended use
The pellet fireplace is intended for indoor use and may only be oper-
ated in enclosed spaces. The place of installation and chimney duct
must comply with the technical and local requirements and provi-
sions! Any use other than that described in this manual is consid-
ered to be misuse and is improper use. Modifications, attachments
or conversions which are made without written approval from
Olsberg may result in damage and risks. This is not permitted and
results in invalidation of the warranty!
1.6 Presentation of information
● Point at the beginning of the line for instructions
ū Dash at the beginning of the line for lists
Symbols
Wear protective gloves
Numbering of a
5
product component
Check or look at
Power on
Right
Read documentation
Unscrew
a screw
Tighten
a screw
Safety symbols
Warning!
Non-compliance results in immediate and serious
personal injury or death!
Caution!
Serious personal injury
and/or environmental damage!
Attention!
Risk of moderate personal injury and/or product
and property damage!
We reserve the right to make technical changes
Note or useful additional
information
5
Numbering,
order, step
Align/plumb
Power off
Wrong
Measure
Loosen a
screw slightly
Tighten a
screw slightly
Risk level III
Risk level II
Risk level
I
1.7 Warnings and safety information
Warning! Very serious personal injury, environmental and
property damage owing to risk of explosion and fire, as well
as owing to heat exposure! Non-compliance results in
immediate and serious personal injury or death!
● Ensure that there is a sufficient distance between the pellet fire-
place (incl. chimney flue) and curtains, carpets, upholstered furni-
ture and other flammable materials!
● Installation on and by flammable materials is not permitted!
● Observe the specified minimum distances during installation and
use of the pellet fireplace!
● Never use flammable liquids such as petrol, lamp oils similar to pet-
rol, petroleum, firelighters, or similar liquids to kindle or "reignite" a
fire! And make sure that such liquids are a sufficient distance away
from the pellet fireplace during operation!
● Do not use the pellet fireplace if the door seals are damaged!
● Do not install the pellet fireplace together with a ventilation sys-
tem which generates a vacuum of (≥ 8 Pa) (seal up to 8 Pa in ac-
cordance with DIBt approval).
● Take care to ensure safe operation, particularly in adverse feed pres-
sure conditions or bad weather.
Caution! Risk of serious personal injury and/or environmen-
tal damage!
● Please note that parts of the surface of the pellet fireplace, as well
as handles, operating levers or locks, get very hot! Only touch
these parts with suitable protection.
● You should also take care to ensure that you are not in the direct
radiation range of the pellet fireplace and do not touch hot sur-
faces with clothing when using the touch control panel.
● The pellet fireplace may only be fired with pellets which comply
with DIN EN 14961-2 and the DIN-plus certification programme or
the Austrian standard M 7135 (max. diameter 6 mm; max. length
30 mm; max. moisture 10%)!
● Pellets must be stored in a dry and dust-free place.
● Instruct children or people with reduced mental capabilities in
dealing with hot surfaces in order to prevent a risk of burns!
● Dispose of the packaging remains immediately! (Risk of suffoca-
tion if swallowed by small children)!
Attention! Product and property damage!
● Observe the maintenance information!
● Clean the pellet fireplace regularly and observe the cleaning in-
structions in order to prevent damage to or premature ageing of
the pellet fireplace!
Note! The pellet fireplace has general type approval from
the Deutsches Institut für Bautechnik (German Institute for
Construction Engineering, DIBt) for balanced flue operation.
VESTA 6 kW
39