Fulgor Milano FCO 6215 TEM Instructions Pour L'installation Et L'utilisation page 72

20 - Solving Operational Problems
EN
Before contacting service, check the following to avoid unnecessary service charges.
Oven Problem
Other F__ Error appears in the display window.
The oven display stays OFF
Cooling fan continues to run after oven is turned off
Oven is not heating
Oven is not cooking evenly
Oven light is not working properly
Oven light stays on
Clock and timer are not working properly
Excessive moisture
Porcelain chips
34
Problem Solving Steps
Remove power and turn it back on again after a few seconds. If condition
persists, note the code number (in the EVENT LOG list) and contact service.
Turn off power at the main power supply (fuse or breaker box). Turn
breaker back on.
If condition persists, call an authorized service.
The fan turns off automatically when the electronic components have
cooled sufficiently.
Check the circuit breaker or fuse box to your house. Make sure there is
proper electrical power to the oven. Make sure the oven temperature has
been selected.
Refer to cooking charts for recommended rack position. Always reduce
recipe temperature by 25°F (15°C) when baking with Convection Bake
mode.
Replace or reinsert the light bulb if loose or defective. See Page 35.
Avoid touching the bulb glass with bare fingers as finger oil may cause
bulbs to burn out prematurely.
Check for obstruction in oven door. Check to see if hinge is bent or door
switch broken.
Make sure there is proper electrical power to the oven. See the Clock
sections on Page 14.
When using Bake mode, preheat the oven first. Convection Bake and
Convection Roast will eliminate any moisture in oven (this is one of the
advantages of convection).
When oven racks are removed and replaced, always tilt racks upward and
do not force them to avoid chipping the porcelain.