Fulgor Milano FCO 6215 TEM Instructions Pour L'installation Et L'utilisation page 46

EN
Connection to the electrical power mains
WARNING
This apparatus must be earthed.
The oven is only for domestic use.
The feed voltage and the absorbed power are as indicated on the data
plate attached to the left-hand side upright, which can be seen when
the oven door is open.
Connecting must be carried out by qualified personnel and in
accordance with the regulations currently in force.
The manufacturer can not be held responsible for any damages to
persons or objects caused by failure to observe these instructions.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a
hazard.
The oven must be connected to the mains through a multipole circuit
breaker with a contact-to-contact gap of at least 3 mm, making sure
that the earth wire is not disconnected. For connecting use a flexible
cable remembering to make it long enough to allow the oven to be
removed from its housing unit when maintenance work is required.
Such a device must be fitted to the power supply in compliance with
the regulations
governing electrical installations.
8
The socket or switch must be easily reachable with the oven fully
installed.
CABLE TYPES AND MINIMAL DIAMETERS
H05RR-F 3x1,5 mm²
H05VV-F 3x1,5 mm²
H05RN-F 3x1,5 mm²
H05V2V2-F 3x1,5 mm²
SASO
H05RR-F 3x2,5 mm²
H05VV-F 3x2,5 mm²
H05RN-F 3x2,5 mm²
H05V2V2-F 3x2,5 mm²