Fulgor Milano FCO 6215 TEM Instructions Pour L'installation Et L'utilisation page 70

EN
4. Slide out the internal glass as shown below. Pull out the second and
third glass panels (intermediate panels) to clean them.
5. Replace the middle panes after cleaning in reverse order, checking
that they are oriented so the words INTERNAL SIDE are properly
legible.
NOTE: a slight gap between the middle panes and the side supports
is normal because it allows for the heat expansion of the
glass.
6. Place the inner glass between the two uprights and put the upper
strip back in place.
32
Replacement of the oven light
WARNING
Make sure that:
• The oven and lights are cool and power to the oven has
been turned off before replacing the light bulb(s). Failure to do so
could result in electrical shock or burns.
• The lenses must be in place when using the oven.
• The lenses serve to protect the light bulb from breaking.
• The lenses are made of glass. Handle carefully to avoid
breakage. Broken glass could cause an injury.
3
1
2
(230V - 25W G9)
(230V - 15 or 25W)
2
3
1
1 Turn off power at the main power supply (fuse or breaker box).
2 Remove the lens (1).
3 Remove the light bulb (2) from its socket (3).
4 Replace the bulb (2) with a new one. Avoid touching the bulb with
fingers, as oils from hands can damage the bulb when it becomes
hot.
5 Use one with the same Volt and Watt (see figure).
6 Screw the lens (1) back on.
7 Turn power back on at the main power supply (fuse or breaker
box).
1
2
(230V - 25W G9)